\documentclass{article}
\usepackage{times}
\usepackage{uist04}
% \documentstyle[times,uist04]{article}
\begin{document}
\bibliographystyle{plain}
\title{Standard UIST 2004 Conference Format:\\
Preparing Camera-Ready Submissions}

%%
%% Note on formatting authors at different institutions, as shown below:
%% Change width arg (currently 7cm) to parbox commands as needed to
%% accommodate widest lines, taking care not to overflow the 17.8cm line width.
%% Add or delete parboxes for additional authors at different institutions. 
%% If additional authors won't fit in one row, you can add a "\\"  at the
%% end of a parbox's closing "}" to have the next parbox start a new row.
%% Be sure NOT to put any blank lines between parbox commands!
%%

\author{
\parbox[t]{7cm}{\centering
	     {\em Author One}\\
	     User Interface Laboratory\\
             ABC Corporation\\
	     1234 Anywhere Road\\
	     Anytown, NY 10027 USA\\
	     +1-212-555-1212\\
	     one@abc.com}
\parbox[t]{7cm}{\centering
	     {\em Author Two}\\
	     Universit\'{e} de XYZ\\
	     5678 rue des Parapluies\\
	     99099 Cr\`{e}me de Menthe, FRANCE\\
	     +33-12-34-56-78\\
	     deux@uvw.xyz.fr}
}

\maketitle

\abstract
Each paper should begin with an abstract, followed by a set of keywords, both
placed in the left column of the first page under the left half of the title.
All body text, such as this paragraph, should be set in 10 point Times Roman
type, with 11 points between successive baselines.  (We will repeat that later
in this document to make sure that you do not forget.)

\keywords Guides, instructions, formatting 

\tolerance=400 
  % makes some lines with lots of white space, but 	
  % tends to prevent words from sticking out in the margin

\section{INTRODUCTION}
The UIST proceedings represent the final archival records of
the conference.  We would like the proceedings to have a
uniform, high quality appearance.  To accomplish this, authors must follow
the format specified here.

In essence, we ask that whatever text formatting program you use,
you format your paper exactly like this document.  Please
match the type style, type size, line spacing, indentation, and layout
format as closely as you can.  In fact, if you received this document online
as a LaTeX file, along with its accompanying uist04.sty style file, you can
use it as a template.

Use an A4 or 8.5"$\times$11" sheet of paper. Center the image on the page.
The whole image of your text must {\em completely} fit in a 17.8 cm$\times$24 cm box. 
Your submission will be photographed 1:1
(no reduction) for 
printing. If you are not using LaTeX with the uist04.sty style
file, then the recommendations we have included here should help you match this
sample with the facilities you do have, such as Microsoft Word.

\section{FIRST PAGE COPYRIGHT NOTICE}
Remember to leave 2.54 cm of blank space at the bottom of the left
column of the first  page,  as on this page. You must leave this space for
the copyright notice on {\em all} submissions intended for publication in the
proceedings. 
 
Please note that the first author of all accepted submissions
will have to sign a copyright release form.  This form will be sent with
the acceptance letter and must be returned with the camera-ready
copy.

\section{PAGE COUNT LIMITS}
Submissions have the following page limits:
\begin{itemize}
\item Papers: 10 pages maximum
\item TechNotes: 4 pages maximum
\end{itemize}

\section{TITLE AND AUTHORS}
The title, author's names and affiliations run across the full width of the
page.  We also recommend phone number and e-mail address, if available.  (See
the top of this page for an example of two names with different addresses.
If only one address is needed, center all text on the page.) 

Here are the typographic details:
\begin{itemize}
\item Title area: 1 column, 5.9 cm length, 17.8 cm width.
\item Title: 18 point Helvetica Bold---mixed cases
\item Names: 12 point Times Italic
\item Addresses, Telephone, E-mail:  12 point Times Roman
\end{itemize}

\section{COLUMN FORMAT}
All body text should be in 10 point Times Roman, with 11 points between
successive baselines.

After the title use a double-column format as shown here. Column width is 8.5
cm, with 0.8 cm between columns (for a total image width still equal to 17.8
cm).  Total text length should remain between 23.2 and 24 cm.
Right margins should be justified, not ragged.   Separate each paragraph by a
blank line (and do not indent them)  Hyphenation is at your own discretion.
If at all possible, the two columns of the last page should be of equal length.
(The  LaTeX uist04.sty file does not do this automatically, so
you will need to insert the commands \verb+\linebreak+ and \verb+\newpage+
at an appropriate point on the last page to justify the current line and
force a new column.)

\section{SECTIONS}
The title of a section should be in 9 point Helvetica Bold font in all
capitals. Notice that the sections, subsections, and subsubsections are not
numbered in this document, but you may number them if you want.

\subsection{Subsections}
The title of a subsection should be in 9 point Helvetica Bold with only the
initial letters of each word capitalized. (Note: Words like ``the'' and ``a''
are not capitalized unless they start a title.)

\subsubsection{Subsubsections.} The heading for a subsubsection should be in
9 point Helvetica Oblique (italic) with initial letters
capitalized. (Note: Words like ``the'' and ``a'' are not capitalized
unless they start a title.)  The subsubsection heading should {\em not}
appear on its own separate line. 

\section{TYPESETTING}
Please use the fonts specified in this description
so that we can produce a conference proceedings that looks like a unified
document, rather than a collection of unrelated papers thrown
together.  The body of your paper should use 10 point Times Roman type,
set with an 11 point vertical spacing between baselines (also known as
1 point of leading).
Do not use a sans-serif font (e.g., Helvetica),  except for emphasis, headings
and the title, as described above.
Computer Modern Roman or another font with serifs should be used {\em only} 
as a last resort if Times Roman is not available. 
Macintosh users should use the font named Times.

Please make sure your printer's toner controls are set to produce solid black
type; grey type will not reproduce well!

If you do not have a laser printer, please try to borrow one,
rent one, or make friends with somebody who has one.  In most cities, you can
bring a diskette to a local copy center, which will print your document for
you.

\section{PAPER}

Please use paper that is appropriate for your printer. Laser printing
should be done on paper that is designed for laser printers. You will
get especially good results with the premium brands of laser printer
paper that are designed for reproduction.  You will get especially {\em
bad} results if you feed your laser printer rough-surfaced high-quality
rag stationery designed for typewriters or pen and ink: the toner will
not adhere to it properly!

\section{FIGURES}

Figures should be inserted at the appropriate point in your text, or
optionally floated to the top or bottom of the page, as was done with
Figure \ref{fig-example}.  If necessary, figures can extend up to the
width of the full two columns: 17.8 cm.  Black and white photographs
(not Polaroid prints) may be mounted on the camera-ready paper with glue
or double-sided tape.  (Please note that even clear tape mounted over
figures or text will cause a noticeable smudge; attach figures only from
behind.)

For better quality you can have stats or screened velox prints that are up to
150 lines per inch prepared by your local printing service. Alternatively, you can
do it yourself with a sufficiently good scanner.

\begin{figure}[tb]
\vspace{1.9in}
\caption{A figure caption.  It is set in 9 point Helvetica type, with a
0.5 cm wider margin on both left and right sides.} 
\label{fig-example}
\end{figure}

If you are imagesetting halftones, instead of pasting in photographs, please
make sure that you do not use a halftone screen frequency greater than
150---higher values may look great on your original, but they will not
reproduce properly when your paper is printed!  If you didn't understand that
last sentence and are typesetting images using PostScript, you may well
encounter this problem, so read on. PostScript printers use a default halftone
screen frequency (the number of variable-sized halftone dots per linear inch)
that depends on the printer resolution.  The defaults on 300dpi or 600dpi
printers will reproduce fine, and if this is the kind of printer you will be
using, you shouldn't have a problem, and can continue with the next paragraph.
The problem occurs if you send your PostScript file to a high-resolution (e.g.,
2400dpi) imagesetter.  This printer's default screen frequency may well be too
high! If you are using a high-resolution imagesetter, you should request that
the administrator set a default screen frequency of at most 150 for your job;
alternatively you can have someone who knows PostScript well help you hardwire
a PostScript ``setscreen'' command into your file.

\section{REFERENCES AND CITATIONS}
Your references should appear in the standard CACM format: a numbered list at
the end of the paper, ordered alphabetically by first author, and referenced by
number in brackets as shown here~\cite{henry-etal92,badenov91,zaranka81}.
(See the examples of citations at the end of this document, and the other
examples on p. 12 of the April 94 issue of the {\em Communications of the
ACM.}) 
References should be materials accessible to the public:
books, articles in standard journals, and papers in open conference
proceedings. 
Internal technical reports should be avoided unless easily accessible (i.e. you
can give the address to obtain it).  Personal communications should be
acknowledged, not referenced.

\section{HEADERS, FOOTERS AND PAGE NUMBERING}
Do not use headers, footers, footnotes, or page numbers on your camera-ready
copy. Nothing should
appear in the margins of your paper!!!
Page numbers, footers and headers will be added by us when the conference
proceedings are assembled.
(That said, initial review submissions {\em only} should have page numbers to
make it easier for reviewers to refer to parts of your paper.)

When submitting camera-ready copy of an accepted submission, please lightly
number your pages 
{\em on the back} using a non-reproducing ``photo-blue'' pencil (obtainable
at a stationery store), labeling page {\em m} of your
{\em n}-page paper with your name and page number:
``FirstAuthor: {\em m} of {\em n.}''
This will help assure that your pages stay in order.  (Remember that
many of the people handling the printing of your paper will not be familiar
with its subject material and won't otherwise be able to tell if the pages get
out of order!) 

\section{OTHER CONSIDERATIONS}
\subsection{Private Material}
Presentations should not contain any proprietary or confidential
material. Please clear all materials before submitting or presenting them.
Submission of pictures of identifiable people should be done only with the
understanding that responsibility for obtaining appropriate permissions rests
with the paper's authors.

\subsection{Equations}
Displayed equations should be centered, with optional, right-justified equation
numbers. 

\subsection{Spelling}
Spelling may follow any English dialect (e.g., British, Canadian, or American)
but be consistent.

\subsection{Language}
The language of UIST is English for an international audience.
Please avoid puns and slang, since English will not be
\linebreak
\newpage
the native language of many readers.  Please be sensitive in
your handling of gender-linked terms.  Avoid gender-specific
expressions when unnecessary; consider using the plural or
replacing third person singular possessives with
articles (e.g. ``a'' rather than ``his''). 

\section{ACKNOWLEDGMENTS}
This document is based in large part on the CHI '94 formatting guidelines.

%%%	You can use bibtex if you like, but I've hardwired in these 
%%%	references to avoid sending you a separate .bib file.
\begin{thebibliography}{9}

\bibitem{badenov91}  Badenov, B. Effects of prolonged use of WIMP user
interfaces on Alces americana and Glaucomys volans.
In {\em Proceedings of UIST '87}
(February 30--April 1, Graceland, TN), ACM, NY, 1987, pp. 231--240.

\bibitem{henry-etal92} Henry, T.R., Yeatts, A.K., Hudson, S.E., Myers, B.A.,
and Feiner, S.K.  A nose gesture interface device: Extending virtual realities.
{\em Presence 1}, 2 (Spring 1992), 258--261.

\bibitem{zaranka81} Zaranka, W., Ed. {\em The Brand-X Anthology of Poetry:  A
Parody Anthology.}  Apple-wood Books, Cambridge, MA, 1981.
\end{thebibliography}

\end{document}
